dialelec.com

001-0034 Datasheet

Stock & Ordering: Octopart | Findchips

001-0034

RF/IF And RFID - RF Antennas - ANT MFLEXPIFA DUAL 2.4/5GHZ MHF1

The World's First Flexible Pifa (patented) Dual-band Antenna Specifically Designed For Installation

On Metal Surfaces. The Flexible Pifa Design Provides For Consistent Performance Across A Broad Array

of enclosures and enables adhering the antenna to flat and curved surfaces.

Specifically tuned for direct mounting on metal surfaces.

Ability To Be Flexed In Either Concave Or Convex Directions Without Sacrificing Antenna Performance,

providing more flexibility in placement of antenna.

Small Size And Adhesive-backing Give Further Mounting Flexibility Within Your Product Design

Both 2.4 Ghz And Dual-band 2.4/5.5 Ghz Antennas Available To Best Address Your Technical

Application

Operating Frequency (mhz) Peak Gain - Typ (dbi) Peak Gain - Max (dbi) Vswr (typ) Vswr (max) Max Gain

30 Above Horizon (dbi) Efficiency (%) Nominal Impedance (ohms) Max Power @ 25 C (watts)

Polarization Azimuth Beam Width

Dimensions - mm (in.) Weight - g (oz.) Cable Type

2400 - 2480 1.7 1.9

N/A 37

50 10 Linear H/V for each radiator Omnidirectional

4900 - 5900 5.2 5.8

4.6 49

29.5 x 26.5 x 2.6 (1.16 x 1.043 x 0.102) 0.0034g

1.13, Grey

Operating Temperature Storage Temperature Material Substance Compliance

-30 C to +70 C (-22 F to +158 F) -40 C to +85 C (-40 F to +185 F)

RoHS Compliant

001-0034

120 +5/-0

ANT-DS-mFlexPIFA-dual 1018

This Section Provides Recommendations For Placement Of The Mflexpifa Dual Band Antenna. This Section

Also Provides Recommendations To Help Prevent The Following Degradations: Degradations To

Reflection Parameters Of The Antenna (vswr Or Return Loss) Degradations To The

Spatially-averaged Gain Or Efficiency Of The Antenna Ak Gain Or Directivity Of The Antenna

Ground plane (Brass Sheet)

The Mflexpifa Dual-band Antenna Is Designed To Be Attached To Metal Surfaces Encountered In

Packaging Of Wireless Communications Devices. The Nominal Attachment Surface That Is Used In Its

Design And Characterization Is A 100 Mm X 100 Mm, X.x Mm Thick, Brass Sheet. The Antenna Should Be

centered within the lateral plane of the metal sheet as shown in Figure 1.

Antenna assembly centered on 100 mm x 100 mm

ground plane (brass sheet)

Figure 1: Nominal Placement Of The Mflexpifa Dual-band Antenna On 100 Mm X 100 Mm, X.x Mm Thick,

brass sheet

Durimnignimtuhmespdaceinsgign And Development Of The Mflexpifa Dual-band Antenna, Perturbation

studies were conducted to check proximity effects of between two 100 mm X